Allied Telesis 86241-02 manual PCR 02369 Module IPGNetwork affecting No

Page 7

Patch 86241-02 For Rapier Switches and AR800 Series Modular Switching Routers

7

PCR: 02365

Module: SWI

Network affecting: No

Address learning on the mirror port is now correctly re-enabled when it is

no longer the mirror port.

 

PCR: 02367

Module: SWI

Network affecting: No

New commands have been added to enable the addition and deletion of static multicast addresses to and from the multicast forwarding table. The new commands are:

ADD SWITCH MULTICASTADDRESS IP=ipadd VLAN=vlan-id

PORT=port-list

DELETE SWITCH MULTICASTADDRESS IP=ipadd VLAN=vlan-id

PCR: 02369 Module: IPGNetwork affecting: No

When the SET IP ROUTE command was executed to change any parameter other than METRIC1, which is the RIP metric, the RIP metric was reset to 1. This metric is now only updated if a value for the parameter is specified.

PCR: 02371 Module: FIREWALLNetwork affecting: No

When the system time was set to a time that was before or significantly after the current time, Firewall sessions were prematurely deleted. This issue has been resolved.

PCR: 02376 Module: PPPNetwork affecting: No

When the PPP ONLINELIMIT was exceeded for PPP over TDM, the PPP link stayed open, allowing Link Quality Report (LQR) packets to be transmitted. This caused the ifOutOctets counter to increment. Now, if the ONLINELIMIT is exceeded, the link will close.

PCR: 02378 Module: SWINetwork affecting: No

Entering 63 for the EPORT parameter in the ADD SWITCH L3FILTER command caused a fatal error. This parameter now accepts the values 63 and 64.

PCR: 02395

Module: VRRP, TRG

Network affecting: No

The SHOW VRRP command now shows the number of trigger activations

for the Upmaster and Downmaster triggers.

 

PCR: 02397

Module: DVMRP

Network affecting: No

After a prune lifetime had expired, the interface was not joined back to the

DVMRP multicast delivery tree. This issue has been resolved.

PCR: 02398

Module: IPV6

Network affecting: No

The following issues have been resolved:

It was possible to assign the same network on different IPV6 interfaces

The loopback address was being added to other interfaces

The tunnel configuration was not showing correctly in IPV6 configuration commands

RIPv6 now sets the metric of routes for interfaces that are DOWN to 16, and immediately sends responses when the link status of VLAN interfaces changes.

Patch 86241-02 for Software Release 2.4.1 C613-10340-00 REV B

Image 7
Contents Introduction Features PCR Module TELNET, TTY Network affecting No PCR Module IPG, PIM, SWI Network affecting NoPCR Module Tpad Network affecting No PCR 02277 Module Dvmrp Network affecting No PCR Module IPv6 Network affecting No PCR Module Install Network affecting No PCR Module STP Network affecting No PCR Module Classifier Network affecting No PCR Module FR Network affecting NoPCR Module IPG/FIREWALL Network affecting No PCR Module IPG, ETH Network affecting NoPCR Module FFS, FILE, TTY Network affecting No PCR 02346 Module BGP, IPGNetwork affecting NoPCR 02348 Module Enco Network affecting No PCR Module SCC, SYN, PPP Network affecting NoPCR 02378 Module SWINetwork affecting No PCR 02369 Module IPGNetwork affecting NoPCR 02371 Module FIREWALLNetwork affecting No PCR 02376 Module PPPNetwork affecting NoPCR Module SNMP, CORE, SHOW, Network affecting No PCR Module Trace Network affecting NoPCR Module IPG Network affecting No Module Vrrp PCR 02463 Module DVMRP, IPG Network affecting No PCR 02450 Module IPV6Network affecting NoPCR 02452 Module IPv6Network affecting No PCR 02457 Module IPV6Network affecting NoPCR Module Switch Network affecting No PCR Module DHCP, IPG Network affecting No AvailabilityPatch Release Note