JVC PU30425 Enter Programme Stop Time, Engage RECORDER’S Timer Mode, TV Prog +, Press TV PROG. +

TIMER

6

q

7 SP/LP

			2	DAILY
		1	2
				3
		4	5	6
	: PDC	7	8	9	WEEKLY
						9
			0		TIMER
				DATE+/	TV PROG. 6
7	SP/LP	–			5
		STOP+/		–
	4
		1		3	OK 8

NOTES:

●For safety, your recorder disables all other functions while in the Timer mode. If you want to use the recorder but its Timer mode is engaged, press TIMER and all other functions are operable. To re-engage the timer, press TIMER.

●You can programme this recorder to timer-record as many as 8 programmes. If you try to programme the recorder to record a ninth, "PROGRAM FULL" appears on screen and "FULL" appears on the front display panel. To record the extra programme, you must first cancel any unnecessary programmes (☞ pg. 32).

●To timer-record a satellite broadcast through a satellite receiver connected to the AV2 IN connector on the back of the recorder, in step 6 above, set "TV PROG" to "AUX2" by pressing TV PROG. +/–. Before the selected programme begins, select the appropriate channel on the satellite receiver, then set the receiver's timer. If your satellite receiver doesn't have a timer, leave the unit's power switched on.

31

ENTER PROGRAMME STOP TIME

4	Press STOP +/– to enter the time you want recording to
	stop.
	● If you are using the Illumi-Guide feature, the following
	buttons remain lit: START +/–, STOP +/–, DATE +/–,
	and TV PROG +/–.
5	ENTER PROGRAMME DATE
	Press DATE +/–. (The current date appears on screen.
	The date you enter appears in its place.)
	● If you are using the Illumi-Guide feature, the following
	buttons remain lit: START +/–, STOP +/–, DATE +/–,
	and TV PROG +/–.
6	ENTER PRESET POSITION
	Press TV PROG. +/–.		PROGRAM 1
			START	STOP
			21 : 00	22 : 00
			SP		ON
			DATE	TV PROG
			25. 12	1
			[+ –] : SET =		BBC1
				: OK
		SP
		D	M

●If you are using the Illumi-Guide feature, OK blinks when the following buttons are lit: START +/–, STOP +/–, DATE +/–, and TV PROG +/–.

7	SET TAPE SPEED
	Press SP/LP to set the tape speed.
	IMPORTANT
	If you’re not receiving PDC (Programme Delivery
	Control), press	: PDC (NUMBER key “7”) to set
	to "OFF" (☞ pg. 33).

	RETURN TO NORMAL
8	SCREEN
	After confirming all information is correct, press OK
	and the normal screen appears.
	● Repeat steps 1 – 8 for each additional programme.

ENGAGE RECORDER’S

TIMER MODE

9 Press TIMER.

To Timer-Record Weekly Or Daily Serials . . .

. . . anytime during steps 2 through 8, press WEEKLY (NUMBER key “9”) for weekly serials or DAILY (NUMBER key “8”) for daily serials (Monday – Friday).