Radio Shack PRO-28 owner manual Resetting the Scanner

20-508.fm Page 37 Wednesday, August 4, 1999 1:50 PM

	PROBLEM	POSSIBLE CAUSE	REMEDY
Keypad does not		The keylock function is	Press KEYLOCK until	dis-
work.		activated.	appears from the display to
			turn off the keylock.
		The batteries are weak.	Recharge the recharge-
	flashes on the dis-		able batteries, or replace
play			the non-rechargeable bat-
			teries.
Error appears on		Programming error.	Reprogram the frequency
the display.			correctly.
In the scan mode,		Programmed frequen-	Avoid programming fre-
the scanner locks		cies are the same as	quencies listed under “Bird-
on frequencies that		“birdie” frequencies.	ie Frequencies” or only
have an unclear			listen to them manually.
transmission.

RESETTING THE SCANNER

If the scanner’s display locks up or does not work properly after you con- nect power, you might have to reset the scanner.

Caution: This procedure clears all the information you have pro- grammed into the scanner. Before you reset the scanner, try turning it off and on to see if it begins working properly. Use the following proce- dure only when you are sure your scanner is not working properly.

1.Turn off the scanner.

2.While you press and hold down the 2 and 9 keys, turn on the scan- ner.

37