PH5000W/D1

SIGNAL SENSOR: This feature allows you to eliminate the use of a remote wire to turn on your amplifier. In AUTO mode the amp will automatically detect an incoming signal when the stereo is turned on. If the amplifier does not detect a signal within 20min. it will automatically shutdown. When in REMOTE mode the amplifier relies on the remote wire to detect a signal.

FUSE RATING SHOULD BE

NO LESS THAN 120 AMPERES

Auto On Remote On

•Test the alternator output. Factory alternator will produce 60 to 80 amperes at best. Wear and heat will reduce the output by 40%.

•Alternator ground (-) must be reinforced, use 4-gauge cable instead of the factory 8-gauge.

•Alternator positive (+) to battery (+) must be reinforced. Use 4-gauge cables.

•Check your battery condition. Batteries degrade after a while.

•Battery (+) to amplifier (+) , must be a 4-gauge cable.

•Ground amplifier to chassis using 4-gauge cable, keep the cable short (maximum 2-feet).

•Use 1 farad capacitor to compensate for surges in demand.

•We recommend the use of one (1) auxiliary battery.

One Subwoofer

For best performance, set the crossover knob to 200Hz (max). Set the gain to minimum, and slowly raise the gain. In general, an ideal gain setting ranges between the 9 to 10 O' Clock position

DO NOT SOLDER THE TIP OF THE POWER CABLE (+&-). IT REDUCES THE CONTACT SURFACE BETWEEN THE CABLE AND THE I N S I D E O F T H E T E R M I N A L . W H E N TIGHTENING THE SCREW, A RAW CABLE (NO SOLDER) EXPANDS INSIDE THE TERMINAL CREATING LARGER CONTACT SURFACE; THUS ELIMINATING HOT JUNCTIONS.

The gain knob is not a volume control. It is designed to match the input level of the amp to the output level of the source unit. Over driving -clipping- the input stage of the amp will cause damage to the amplifier (Please refer to table for settings).

Two Subwoofers

GND

BAT

To battery (+)

To car chassis / ground

To remote turn on / trigger

14			15
	Specifications Are Subject To Change Without Notice	www.earthquakesound.com