Features Explained

Earthquake Sound

SPEAKER OUTPUT

FUSE

110-120VAC-60Hz

220-240VAC-50Hz

Amplifier section Explained

Rear Gain Control Limiter (RGCL)

It controls the front pad maximum output power from over powering small speakers. The module RGCL will limit the output only when the RCA input selection is set to MAIN (not Bus).

Input Signal Control(ISC)

When switched to LOCAL, individual inputs will drive each individual amplifier.

When selecting BUS, the audio LR input from the BUS will drive the

amplifier.

Mono/ Stereo input control

You must switch to MONO when the amplifier is wired for MONO

Phoenix type connector

		BUS section Explained
		Bus Control Limiter (BCL)
		It controls the front pad maximum output power
		from over powering small speakers. The module
		BCL would limit the output power of any amplifier
		that uses the bus as a signal source.
	L	R
		Bus RCA input signal
		Stereo input signal RCA that delivers the signal to
		the bus. It also allows you do daisy chain the
Keypad Front view		signal to additional Cinénova amplifiers.
Keypad Front view	L	R
		DC TRIGGER
		12 Volt DC trigger to be connected to source
		output 12 volt trigger. For this to operate, you need

Should be wired using CAT5 or 5e, CAT6 or 6e. This allows zone control via IR. This must be connected to the zone pad.

Speaker output terminal

For stereo applications, please follow the polarity that is shown on top. For MONO follow the bottom polarity.

Please note that FFI is a Fault Fuse Indicator. Any amplifier that has the FFI LED light on will require a fuse replacement or possibly service.

L R

	to switch the front panel switch to OFF.
	4 IR repeater
	The Cinénova-IR16 has four output IR that
	combine any or all zone IR input. These repeater
	will repeat the sum of IR signal to control any
Keypad Rear view	source input. Please note that you will need to use
Keypad Rear view	your source remote, aim it at the pad and it will
	deliver the IR signal to the source.