5. Pritner Specification
5-1 Specification
|
|
|
Printing Method |
| Direct Thermal |
|
|
|
Printing Speed |
| 80mm/sec |
Resolution |
| 203 DPI X 203 DPI |
|
|
|
Character |
| Font A (12X24), Font B (9X17) |
Character per line |
| Font A : 32 columns , Font B : 42 columns |
|
|
|
Character set |
| ALPHA NUMERIC Charactor, Extension grapic |
Barcode |
| |
|
| Coda bar, Code93, Code128 |
Emulation |
| ESC/POS |
|
|
|
Driver |
| Window CE 4.2 & 5.0, Window Mobile 5.0 |
|
|
|
Sensor |
| Paper End Sensor , Cover open Sensor |
|
|
|
Paper | paper type | Thermal Paper |
|
|
|
| width | 58mm |
| thickness | 65㎕ |
| External Diameter | Max. Φ40mm |
| Internal Diameter | 12.5mm |
|
|
|
Reliability | TPH | 50km |
| Battery | Continuous printing: 29min |
|
| Standby: 10hours 20min |
|
| Printing length: 130m |
|
|
|
Communications |
| |
|
|
|
MSR (Optional) | Card Standard | ISO7811/2, JIS |
| Track | 1Track, 2Track, 3Track, |
|
|
|
| Magnet Head Life | 300,000 Passes(minimum) |
Battery Charger | input | AC100~240V, 50/60 Hz |
|
|
|
| output | 8.4V , 800~1400mA |
Battery | Battery type | |
|
|
|
| output | 7.4V, 1130mAh |
| Charging time | 2hours |
|
|
|
Size | W X D X H(mm) | 96 X 136 X 58 |
| W X D X H” | 3.7 X 5.3 X 2.2 |
|
|
|
Weight |
| 0.4kg |
Temperature | operation | |
|
|
|
| storage | |
Humidity | operation | 35 ~ 95% |
|
|
|
|
|
|
6.Certification
FCC Information
This device complies with part 15 of the FCC Results. Operation is subject to the following two conditions:
(1)This Device may not cause harmful interface, and
(2)This device must accept any interference received, including interference that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for CLASS B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instuctions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try correct the interference by one or more of the following measures:
1.1.Reorient or relocate the receiving antenna.
1.2.Increase the separation between the equipment and receiver.
1.3.Connect the equipment into an outlet on a circuit different from that to which receiver is connected.
1.4.Consult the dealer or experienced radio/TV technician for help.
WARNING
Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment.
18 | 19 |