Source Technologies STM.58B specifications Battery removal, Battery charging

Page 5

3-3 Battery removal

180˚

Put up the Belt clip hole turning 180 degree.

1

2

After putting up the belt clip, remove the battery holding it up as shown above.

3-4 Battery charging

Lamp

1.Be sure that the printer is turned off

2.After open the DC JACK cover, insert DC JACK into the printer.

3.Plug the power code to electrical outlet.

3-4-1 The status of lamp in charging

Status

charging

charging complete

Charging Lamp

Red

Green

 

 

 

NOTE

1.Unless the exclusive charger is used provided by the manufacturer, the printer can be damaged, and the manufacturer is not liable for the consequential damage.

2.Before removing the battery, make sure that power is turned off.

3.Printer does not work in the status of being connected with charger only.

4.The battery should be installed to operate printer.

5.While charging, do not turn on the power.

6.Do not operate the print while charging the battery.

7.Do not connect the charger while the printer is operated.

6

7

Image 5
Contents Model STm.58b Table of Contents Product overview UnpackingControl panel usage Usage and InstallationBattery Installation Battery charging Battery removalUsage of Cigar Jack for charging Battery charger usageBelt Clip usage Roll Paper installationSelf Test Leather case usageMotor protection from being overheated MSR usageInterface Cable Connection Bluetooth ConnectionPeripherals connection Certification Pritner SpecificationSpecification Setting up the software