Aspire Digital H342, H341 manual Bootblock recovery code checkpoints

Checkpoint	Description
D7	Restore CPUID value back into register. The Bootblock-Runtime interface module is
	moved to system memory and control is given to it. Determine whether to execute
	serial flash.
D8	The Runtime module is uncompressed into memory. CPUID information is stored in
	memory.
D9	Store the Uncompressed pointer for future use in PMM. Copying Main BIOS into
	memory. Leaves all RAM below 1MB Read-Write including E000 and F000 shadow
	areas but closing SMRAM.
DA	Restore CPUID value back into register. Give control to BIOS POST
	(ExecutePOSTKernel). See POST Code Checkpoints section of document for more
	information.

Bootblock recovery code checkpoints

The Bootblock recovery code gets control when the BIOS determines that a BIOS recovery needs to occur because the user has forced the update or the BIOS checksum is corrupt. The following table describes the type of checkpoints that may occur during the Bootblock recovery portion of the BIOS:

Checkpoint	Description
E0	Initialize the floppy controller in the super I/O. Some interrupt vectors are initialized.
	DMA controller is initialized. 8259 interrupt controller is initialized. L1 cache is
	enabled.
E9	Set up floppy controller and data. Attempt to read from floppy.
EA	Enable ATAPI hardware. Attempt to read from ARMD and ATAPI CDROM.
EB	Disable ATAPI hardware. Jump back to checkpoint E9.
EF	Read error occurred on media. Jump back to checkpoint EB.
E9 no EA	Determine information about root directory of recovery media.
F0	Search for pre-defined recovery file name in root directory.
F1	Recovery file not found.
F2	Start reading FAT table and analyze FAT to find the clusters occupied by the recovery
	file.
F3	Start reading the recovery file cluster by cluster.
F5	Disable L1 cache.
FA	Check the validity of the recovery file configuration to the current configuration of the
	flash part.
FB	Make flash write enabled through chipset and OEM specific method. Detect proper
	flash part. Verify that the found flash part size equals the recovery file size.
F4	The recovery file size does not equal the found flash part size.
FC	Erase the flash part.
FD	Program the flash part.
FF	The flash has been updated successfully. Make flash write disabled. Disable ATAPI
	hardware. Restore CPUID value back into register. Give control to F000 ROM at
	F000:FFF0h.

46 Chapter 4