Advanced
The Advanced menu screen contains parameters involving your hardware devices. It also provides advanced settings of the system.
PhoenixBIOS Setup Utility
Info. | Main | Advanced | Security | Boot | Exit |
|
|
|
|
|
|
Infrared Port (FIR) | [Enabled] |
Base I/O address: | [2F8] |
Interrupt: | [IRQ 3] |
DMA channel: | [DMA 1] |
Serial port A: | [Disabled] |
Parallel port: | [Disabled] |
Item Specific Help
Configure Infrared Port
using options:
[Disable]
No configuration
[Enabled]
User configuration
Legacy USB Support [Enabled]
| F1 Help | ↑ ↓ Select Item | F5/F6 Change Values | F9 Setup Defaults |
| Esc Exit | ← → Select Menu | Enter Select | F10 Save and Exit |
| ||||
|
|
|
|
|
The table below describes the parameters in the screen. Settings in boldface are the default and suggested parameter settings.
.
Parameter | Description | Options |
|
|
|
Infrared Port | Enables, disables or auto detects the infrared port. | Disabled/Disabled/Auto |
Base I/O address | Sets the I/O address of the infrared port. | 2F8/278 |
|
|
|
Interrupt | Sets the interrupt request of the infrared port. | IRQ3/IRQ5 |
|
|
|
DMA channel | Sets a DMA channel for the printer to operate in | DMA3/DMA1 |
| ECP mode. This parameter is enabled only if Mode |
|
| is set to ECP. |
|
|
|
|
Serial Port A | Enables. disables or auto detects the serial port A. | Enabled/Disabled/Auto |
Parallel Port | Enables, disables or auto detects the parallel port. | Enabled/Disabled/Auto |
34 | Chapter 2 |