Honeywell manual To Connect Demos on the Terminal to the Image View

Page 40

To Connect Demos on the Terminal to the Image View

The following Demos contain a Port Config feature that enables you to connect with Image View on the workstation:

Imaging Demo	Tap Setup > Port Config.
IQ Imaging Demo	Tap Settings > Port Config.
Scan Demo	Tap Setup > Port Config.
Signature Capture	Tap File > Port Config.

A window opens that enables you to configure the radio connection to Image View on the workstation.

Enter the same IP Address and TCP Port that was entered in Image View on the host workstation. These values must match!

When you tap Close, you are prompted to save settings. Tap Yes. The terminal begins connecting immediately.

When you save the settings:

1.You will be able to send data from these Demos to Image View on the workstation when the terminal’s radio is enabled; see Send and AutoSend on page 8-3.

2.These settings are saved to a Demo RF Settings.exm file that is stored in the \IPSM folder so the connection persists through cold boots. Tap Start > Power Tools > EZConfig Utilities > Demo RF Settings.exm.

Note: When you set up Port Config in one Demo, the settings applies to all the Demos.

8 - 2	Rev A	Dolphin® Demos User’s Guide
	8/6/08

Image 40

Contents Dolphin Demos Disclaimer TrademarksPatents Other TrademarksTable of Contents Signature Capture Demo Installing and Accessing Demos Accessing DemosOverview System RequirementsView Options Exiting DemosTap File Exit ESC Acquiring Upgrades Installing an Upgrade to the Workstation Upgrading DemosRev a Dolphin Demos User’s Guide Rev a Installing an Upgrade on the Terminal Folder on the WorkstationDevice Image DocsInstall Locations Rev a Imaging Demo To Capture ImagesTo Save Images SaveDefault Image Settings To Open ImagesImage Profiles Tap File OpenTo Select a Profile Auto CaptureAvailable Image Profiles File Menu MenusImage Menu Setup Menu Help MenuMenu Item Description About Shortcut KeysRev a To Use IQ Imaging Demo IQ Imaging DemoIQ Imaging Types Express Delivery Settings To Save Scanned InformationTo Clear Scanned Information Tap File Save Image or File Save Bar CodeRev a Accessing the Print Demo Print DemoPrinting to a Bluetooth Printer To Run the Print Demo to a Bluetooth PrinterRequirements Tap Start Demos Print DemoRequirements Printing to an IrDA PrinterTo Run the Print Demo to an IrDA Printer Rev a To Use the Scan Demo Scan DemoScan Statistics Field This field displays … Symbol Clearing Scan DataLength CountAuto Scan Delay Auto ScanContinuous Scan CenteringEnable Aimer Decode ModesSound Options Quick Omni Aggressive Linear DecodingSymbologies To Select SymbologiesTo De-Select Symbologies AllRecording Custom Settings Default SettingsTaking Images of Bar Codes Signature Capture Demo To Capture a SignatureTo Clear a Signature Pen Width OptionsTap File Save Tap View Pen Width 1, 2, 3, orGPS Demo Heading TabActivating the GPS Demo For Optimal FunctioningSatellites Tab Logger TabRaw Data Tab Rev a Configuring ImageView on the Workstation Using Image ViewClick File Setup To Connect Demos on the Terminal to the Image View Send and AutoSend Imaging DemoIQ Imaging Demo Scan DemoTo Transmit Demo Data to Image View Technical Assistance Customer SupportOnline Technical Assistance Rev a Page Honeywell