Metrologic Instruments MS770 manual Stand Installation

Page 6

Stand Installation

With the Metrologic stand (Part #45475), the scanner can be positioned in one of two directions. The two orientation choices are vertical or horizontal. (Refer to Figure 1)

To install this stand, use the four 6-

 

32 x ½ inch machine screws and two

 

#10 panhead wood screws.

Figure 1

1.Drill two holes into the work surface that are the same size and distance as the holes on the stand base. (Refer to Figure 2)

2.Use the two #10 panhead wood screws to attach the stand to the work surface.

3.To fasten the scanner:

!For a horizontal mount, align the four holes on the back of the scanner with the four clearance holes located on the stand marked with an X in Figure 3.

!For a vertical mount, align the four holes on the back of the scanner with the four clearance holes located on the stand marked with a Y in Figure 3.

Base of Stand

Figure 2

Figure 3

4.Fasten the scanner to the stand by inserting the four 6-32 x ½ inch screws into the four holes in the scanner’s case.

4

Image 6
Contents Installation and User’s Guide Metrologic INSTRUMENTS, INCTable of Contents Introduction Unpacking ListScanner Installation Configuration to the Host System Stand Installation Back Plate Installation Parts of the Scanner Code has been decodedVisual Indicators Steady GreenSignaux optiques Ni la diode rouge, ni la diode verte nest alluméeOptische Anzeigen Weder rote noch grüne LeuchtdiodenanzeigeSegnali ottici Né il diodo luminoso rosso né quello verde sono accesiLabels Depth of Scan Field for the MS770 Scanner Depth of Scan Field for the MS775 Scanner Maintenance Applications and ProtocolsSpecifications Appendix aOperational Appendix B Pin AssignmentsVersion 15 Pin Assignments for Light Pen Emulation Warranty and Disclaimer Appendix CDisclaimer Appendix D RemarqueAnmerkung Appendix E PatentsIndex AsicMecca