Back Plate Installation |
| |
With the Metrologic back plate |
| |
(Part #45473), position the scanner |
| |
in one of two directions. The two |
| |
orientation choices are vertical or |
| |
horizontal. (Refer to Figure 4). To |
| |
use this stand, use the four |
| |
inch machine screws and four wood |
| |
screws to attach the unit to the back |
| |
plate and work surface. The maxi- |
| |
mum distance the screws should go | Figure 4 | |
into the scanner is a ½ inch. | ||
|
1.Drill four holes into the work surface that correspond with the holes indicated by an XY in Figure 5.
2.To fasten the scanner to the back plate:
!For a horizontal mount, align the four holes on the back of the scanner with the four clearance holes located on the back plate marked with an X in Figure 5.
!For a vertical mount, align the four holes on the back of the scanner with the four clearance holes located on the back plate marked with a Y in Figure 5.
3.Fasten the scanner to the back plate by inserting the four
Figure 5
5