Chauvet Q-ScanTM 250, Q-RollTM 250 user manual Mounting, Ori ent at ion, Warnin g, Rigg ing

Page 8

Introduction

Mounting

Ori ent at ion

Both fixtures can sit on stage or be mounted on a truss using a clamp in any position, provided, there is adequate room for ventilation.

Warnin g

It is important never to obstruct the fan or vents pathway.

When selecting installation location, take into consideration lamp replacement access and routine maintenance.

Safety cables should always be used.

Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes or restricted ventilation.

The fixture must have a minimum of 1 meter distance from combustible materials.

1

2

3

1.Clamp

2.Fixture Yoke

3.Angle Adjustment

Rigg ing

The fixture includes a mounting yoke to which 1 rigging clamp can be bolted.

1.Align the clamp screw with the center hole on the yoke and tighten.

2.Verify the structure can hold 10 times the weight of all to-be installed fixtures.

3.Adjust the angle on the yoke arm as necessary.

Q-Scan 250 & Q-Roll 250 User Manual

8

2005-11-15/13:24

Image 8
Contents Scan Table of Content AC Power Safety InstructionsBefore YOU Begin Is includedDMX Channel Summary Technical FeaturesIntroduction Product Overview Control BoardLam p In stall at ion SetupLamp Pow er Cabl e Conf igu ratio n PowerExchanging gobos Mounting Ori ent at ionWarnin g Rigg ingOperating Instructions Control PanelControl Panel Functions Applying changes to Functions Quick InstructionsOperating Modes Aster & St and Al on e P6Setti ng Slav e F i xtu res Sou nd act ive P4 o r Au to run P5Menu Functions DM X M odeDaisy Ch ai n Conn ecti on Setti ng t he start ing addressP3 Fi xtu re R eset al l m oto rs P1 Pan I nvert / P2 T ilt I nvertP8 D ispl ay I nvert Fixtu re Li nking AppendixDMX Primer DMX Channel Values 16 Bit Shutter/Strobe/DimmerClaims MaintenanceReturns Procedure General Troubleshooting Technical Specifications Technical Support