Adesso 2100 Series manual Scanning Mode Selection

Page 8

7.Scanning Mode Selection

Note: The default setting of the barcode scanner is on Trigger Mode.

Do not program the barcode scanner unless necessary.

 

 

 

 

 

 

 

 

 

 

All program setup must start with reading the “Start” label,

 

 

 

 

 

 

 

 

 

 

and reading the “End of Configuration” label to save any

 

 

 

 

Start

changes.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Trigger Mode (Default)

 

 

 

 

 

 

 

 

 

 

 

The scanner becomes inactive as soon as the data is

 

 

 

 

 

 

 

 

 

 

transmitted. It must be triggered to become active again.

Trigger mode

 

 

 

 

 

 

 

 

 

 

 

Auto Scan Mode

 

 

 

 

 

 

 

 

 

 

 

In auto scan mode, the scanner is still active after the data is

 

 

 

 

 

 

 

 

 

 

transmitted, but the successive transmission of the same bar

 

 

 

 

 

 

 

 

 

 

code is not allowed when the trigger switch is pressed again.

Auto scan mode

Alternate Mode

 

 

 

 

 

 

 

 

 

 

 

This scanner will light up when pressing the scanner trigger

 

 

 

 

 

 

 

 

 

 

switch once. Then the scanner will turn off for the next

 

 

 

 

 

 

 

 

 

 

pressing.

 

Alternate mode

Repeat Mode

 

 

 

 

 

 

 

 

 

 

 

This mode is similar to Auto Scan mode, but duplicate reading

 

 

 

 

 

 

 

 

 

 

of the same barcode is prohibited if the scanner switch is

 

 

 

 

 

 

 

 

 

 

pressed.

 

Repeat mode

 

 

 

 

 

 

 

 

 

 

 

 

Reset Mode

 

 

 

 

 

 

 

 

 

 

 

The reading of the "RESET” label turns all the parameters

 

 

 

 

 

 

 

 

 

 

back to default values.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Reset Mode

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

End of Configuration

5

Image 8
Contents Users Guide Page Table of Contents Limited Warranty General handling precautionIntroduction Product Introduction ContentsBarcode Symbologies Installation MaintenanceTest Scanning USB Connection Host PS/2 ConnectionScanning Mode Selection Beeper Mode Selection MediumDefaultMedium. Do not program the barcode scanner unless necessary Tone DurationBarcode Scan Field Default ParametersFunction Default Values Technical Specifications Programming Guide OperationalTrouble Shooting Problem Scanned data is incorrectly displayed on the hostPossible Cause Possible Solution Product SupportEmail Support Phone Support