Parallel Port Configurations

XRD9829REF

9.Confirm the parallel port address as follows:

a.Select the Start Menu, choose Settings, then choose Control Panel

b.From the Control Panel window which pops up, double-click on System

c.In the System Properties window, select Device Manager

d.From the Device Manager window, double-click on Ports (COM & LPT)

e.Double-click on Printer Port (LPT1). If you can not find it, please goto Step 10

f.From the pop-up window, select Resources

g.Verify the Input/Output Range is set to 0378 - 037F

h.If the range is not correct, clear the Use Automatic Settings check box by clicking it

i.Choose correct address which is 0378 by default and click OK

j.Re-start the computer as advised

10.If you do not have a Printer Port configured on your computer, please follow the steps listed below:

a.From the Control Panel window which pops up, double-click on Add New Hardware

b.From the pop-up window, click the Next > button

c.Select ‘No’ when prompted for ‘Do you want Windows to search for your new hardware?’, then click the Next > button

d.Choose Ports (COM & LPT), then click the Next > button

e.Choose Printer Port, then click the Next > button

f.Make a note of the Input/Output Range of Printer Port of your computer and click OK.

g.You will use these values later when configure the ScanIt software

h.Re-start the computer as advised

Offset Adjustment With a Black Target

11.Set the dip switches located on the side panel of the scanner to 1100010000 as shown in Figure 2 and push the Serial Port button which is located on the front panel of the demo system. This will reset the XRD9829.

Rev. 1.00