Chauvet Q-Scan 150 Operating Modes, Aster & St and Al on e P6, Setti ng Slav e F i xtu res

Operating Modes

∙A stand-alone mode will listen to sound and run through its diverse range of built in programs.

∙Master/Slave mode will allow the command of up to as many units you want in a synchronized light show to the sound.

∙DMX control mode will provide the greatest flexibility and creativity. Each fixture trait can be controlled individually using any universal DMX-512 controller.

M aster & St and Al on e ( P6)

In order to create the correct environment for Stand Alone operation, several parameters have to be set in the control panel. Please make the changes to the functions as listed in the table below.

FUNCTION	SET TO	NOTES
P6	-y	Master mode (one Master only)
P4	-y	Sound activated
A	001	Channel address
P1	Any	Pan invert
P2	Any	Tilt invert

Note!

If the fixture is connected to a controller, please disconnect it.

The display will read the previously selected setting.

Only one fixture can be the Master assigned fixture. However, 16 units can be slaved to the master unit.

Setti ng Slav e F i xtu res

The Master/Slave mode will allow you to link multiple units in a daisy chain fashion. In this mode, the first unit in the daisy chain, the master, will automatically command all other units following. The first unit will operate in a Stand/Alone mode and all units following will synchronize to the first unit. Up to 16 fixtures can be daisy chained in Master/Slave mode.

MENU

P6

P4

A

P1

P2

SET TO	NOTES
-n	Master mode
-n	Sound activated
001	Channel address
Any	Pan invert
Any	Tilt invert

You can change the Pan and Tilt settings freely.

Sou nd - act ive ( P4) o r Au to - run ( P5)

In Master/Slave mode you can choose whether the fixture will run in a sound-active state where the movement is triggered by sound or in auto-run where the speed is pre-programmed.

MENU

P4

or

P5

SET TO	NOTES
-n	Sound Activated
-n	Auto-run

Q-Scan 150 & Q-Roll 150 User Manual 10 2005-11-15/13:23