Chauvet Q-Roll 150, Q-Scan 150 user manual Power, Exchanging gobos, Pow er Cabl e Conf igu ratio n

Page 7

Introduction

Lamp Alignment How-To

Often, after a new installation of a lamp, you will find that there is an uneven field of light or what is referred to as a hot spot. This is due to the most intense point of the lamp source not being positioned optimally within the reflector.

There are three lamp alignment screws provided at the base of the projector head. Turning these screws allow you to optimize the projection quality of the spot as well as the overall intensity of the beam.

1.Project a white spot against any flat surface. Preferably the surface should be white or pastel in color.

S2

Lamp Alignment Screws are accessible via the rear plate.

2.Turning the lamp alignment screws, try to position the hot spot in the center of the beam as best as possible. This could require many attempts on your part.

3.Once the hot spot is in the center of the spot, do your best to turn all screws equally as to affect movement up or down within the reflector.

4.As you move in and out of optimum lamp focus, you will see the hot spot either gets wider or narrower. The goal is to either totally diminish the hot spot by having it widen and spread across the entire spot or moving the hot spot so that it covers as much of the beam spot area as possible.

Power

Your product is equipped with switch-selectable AC power setting.

Warning!

Verify that the power select switch on your unit

 

matches the line voltage applied. All fixtures must

 

be connected to circuits with a suitable Earth

 

Ground.

Slide switch up or down

depending on your line voltage.

To determine the power requirements for a particular fixture,

see the label affixed to the back plate of the fixture or refer to the fixture’s specifications chart.

A fixture’s listed current rating is its average current draw under normal conditions.

All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat

 

(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0%

to 100% switch.

Before applying power to a fixture, check that the source voltage matches the fixture’s

requirement.

All fixtures must be connected to circuits with a suitable Earth Ground.

Pow er Cabl e Conf igu ratio n

CABLE

BROWN

BLUE

YELLOW/GREEN

PIN

Live

Neutral

Earth

INTERNATIONAL

L

N

EG (Ground)

Exchanging gobos

1.Press both tips of the gobo tension ring together and remove from aperture.

2.Push the gobo with your finger from the back side following the same direction that the tension ring was removed.

Q-Scan 150 & Q-Roll 150 User Manual

7

2005-11-15/13:23

Image 7
Contents Scan Table of Content Is included AC PowerSafety Instructions Before YOU BeginIntroduction Technical FeaturesDMX Channel Summary Control Board Product OverviewLamp SetupLam p In stall at ion Exchanging gobos PowerPow er Cabl e Conf igu ratio n Rigg ing MountingOri ent at ion Warnin gApplying changes to Functions Quick Instructions Operating InstructionsControl Panel Control Panel FunctionsSou nd act ive P4 o r Au to run P5 Operating ModesAster & St and Al on e P6 Setti ng Slav e F i xtu resSetti ng t he start ing address Menu FunctionsDM X M ode Daisy Ch ai n Conn ecti onP8 D ispl ay I nvert P1 Pan I nvert / P2 T ilt I nvertP3 Fi xtu re R eset al l m oto rs DMX Primer AppendixFixtu re Li nking Shutter/Strobe/Dimmer DMX Channel Values 16 BitReturns Procedure MaintenanceClaims General Troubleshooting Technical Support Technical Specifications