Sony Digital Studio System manual Connectors, Connector Description

Page 18

6

VAIO Digital Studio System Reference Manual

Connectors

Audio L In jack

Video In jack

S-Video In port

Audio R In jack

i.LINK port

USB1, USB2 ports

Connector	Description
Audio L In jack	Connects to an audio cable (supplied).

Video In jack	Connects to a video cable (supplied).

S-Video In port	Connects to an S-video cable (optional).

Audio R In jack	Connects to an audio cable (supplied).

i.LINK® port	Connects to a digital device that has a 4-pin i.LINK
(IEEE 1394)*	header.
USB1, USB2 ports	Connects to USB devices.

*To connect to a 6-pin i.LINK device, use the i.LINK port on the back of the system. A 6-pin i.LINK connector can supply power from the computer to the device if the device also has a 6-pin i.LINK port. A 4-pin i.LINK connector cannot supply power to the device.

Image 18

Contents Page Owner’s Record Vaio Digital Studio System Reference ManualSafety Information and Caution Vaio Digital Studio System Reference Manual Regulatory Information Telephone Consumer Protection Act United States Disposal of Lithium Battery Industry Canada Notice Contents System Board Index Xii Chapter Identifying Components Front View Drives Drive DescriptionButtons and Switches Button or switch DescriptionIndicators Indicator DescriptionConnectors Connector DescriptionRear View USB3, USB4Icons IconDescriptionOn models equipped with Giga Pocket features Keyboard and Mouse Ports USB PortsEthernet Port Serial Port Printer/Parallel PortVGA Monitor Port Telephone and Line Jacks Link Ieee 1394 Ports Expansion Slots Chapter Configuring Your System Accessing the Bios Setup Utility Changing the Displays Power Management Settings Vaio Digital Studio System Reference Manual Click the Advanced tab Select the desired settings Vaio Digital Studio System Reference Manual Configuring Your System Vaio Digital Studio System Reference Manual Chapter Removing, Installing, Replacing Components Removing the Side Cover Replacing the Side Cover Removing a PCI Add-in Card Removing, Installing, and Replacing Components Installing a PCI Add-In Card Removing, Installing, and Replacing Components Replacing the Lithium Battery Push in not down to pop out battery Vaio Digital Studio System Reference Manual Removing a Memory Module Installing System Memory Memory module configurations MBRemove the AGP add-in card Latch Edge Connector Removing a Slot Cover Covering an Open I/O Slot Installing a 3.5-inch Internal Hard Disk Drive Disconnect the drive connector a in diagram Removing, Installing, and Replacing Components Drive connectors Power connectors Tab Disk drive holder To identify additional hard disk space Removing the Power Supply Replacing the Power Supply Vaio Digital Studio System Reference Manual Chapter System Board Memory Module DDR-DIMM Slots Power Supply and Aux Power Headers Pin Signal NamePin CLR Cmos Jumper Jumper Plug Position FunctionVaio Digital Studio System Reference Manual Chapter Cmos Setup Options Vaio Digital Studio System Reference Manual Main Screen CD-ROM Advanced Screen 2F8H/IRQ3 Power Screen Boot Screen Atapi MOExit Screen Vaio Digital Studio System Reference Manual Chapter Miscellaneous Technical Information User and Supervisor Passwords If you set these passwords Following passwords are requiredBeep Code Error Messages PCI Configuration Status and Error Messages Message MeaningMiscellaneous Technical Information DMA Default Channel Assignment DMA Channel AssignmentsSystem I/O Address Map Address Range hex DescriptionAddresses that may be used by add-in cards are not listed Address range Default configuration Memory MapIRQ Settings IRQChipset Chapter SpecificationsProcessors AGP BusMemory Modules Memory ConfigurationsPCI Bus L2 CacheAudio CommunicationsGiga Pocket I/O Hard Drives and Controllers Expansion SlotsFloppy Disk Drive and Controller Optical DrivesSystem Bios ROMVaio Digital Studio System Reference Manual Index Vaio Digital Studio System Reference Manual Index Vaio Digital Studio System Reference Manual