Sony Digital Studio System manual Replacing the Power Supply

Page 57

Removing, Installing, and Replacing Components

45

Replacing the Power Supply

1 Rotate the power supply down and slide it down along the rails on each side of the chassis opening.

2 Replace the screw that secures the power supply to the rear of the chassis.

Image 57

Contents Page Vaio Digital Studio System Reference Manual Owner’s RecordSafety Information and Caution Vaio Digital Studio System Reference Manual Regulatory Information Telephone Consumer Protection Act United States Disposal of Lithium Battery Industry Canada Notice Contents System Board Index Xii Chapter Identifying Components Front View Drive Description DrivesButton or switch Description Buttons and SwitchesIndicator Description IndicatorsConnector Description ConnectorsUSB3, USB4 Rear ViewIconDescription IconsOn models equipped with Giga Pocket features Keyboard and Mouse Ports USB PortsEthernet Port Serial Port Printer/Parallel PortVGA Monitor Port Telephone and Line Jacks Link Ieee 1394 Ports Expansion Slots Chapter Configuring Your System Accessing the Bios Setup Utility Changing the Displays Power Management Settings Vaio Digital Studio System Reference Manual Click the Advanced tab Select the desired settings Vaio Digital Studio System Reference Manual Configuring Your System Vaio Digital Studio System Reference Manual Chapter Removing, Installing, Replacing Components Removing the Side Cover Replacing the Side Cover Removing a PCI Add-in Card Removing, Installing, and Replacing Components Installing a PCI Add-In Card Removing, Installing, and Replacing Components Replacing the Lithium Battery Push in not down to pop out battery Vaio Digital Studio System Reference Manual Removing a Memory Module Memory module configurations MB Installing System MemoryRemove the AGP add-in card Latch Edge Connector Removing a Slot Cover Covering an Open I/O Slot Installing a 3.5-inch Internal Hard Disk Drive Disconnect the drive connector a in diagram Removing, Installing, and Replacing Components Drive connectors Power connectors Tab Disk drive holder To identify additional hard disk space Removing the Power Supply Replacing the Power Supply Vaio Digital Studio System Reference Manual Chapter System Board Memory Module DDR-DIMM Slots Pin Signal Name Power Supply and Aux Power HeadersPin Jumper Plug Position Function CLR Cmos JumperVaio Digital Studio System Reference Manual Chapter Cmos Setup Options Vaio Digital Studio System Reference Manual Main Screen CD-ROM Advanced Screen 2F8H/IRQ3 Power Screen Atapi MO Boot ScreenExit Screen Vaio Digital Studio System Reference Manual Chapter Miscellaneous Technical Information If you set these passwords Following passwords are required User and Supervisor PasswordsBeep Code Error Messages Message Meaning PCI Configuration Status and Error MessagesMiscellaneous Technical Information DMA Channel Assignments DMA Default Channel AssignmentAddress Range hex Description System I/O Address MapAddresses that may be used by add-in cards are not listed Memory Map Address range Default configurationIRQ IRQ SettingsProcessors Chapter SpecificationsChipset AGP BusPCI Bus Memory ConfigurationsMemory Modules L2 CacheAudio CommunicationsGiga Pocket I/O Floppy Disk Drive and Controller Expansion SlotsHard Drives and Controllers Optical DrivesROM System BiosVaio Digital Studio System Reference Manual Index Vaio Digital Studio System Reference Manual Index Vaio Digital Studio System Reference Manual