Reverse this procedure to install the fan/heat sink assembly.
Display assembly
NOTE: The display assembly is spared at the subcomponent level only. For more display assembly spare part information, see the individual removal subsections.
Before removing the display assembly, follow these steps:
1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect the power from the computer by unplugging the power cord from the computer.
3.Disconnect all external devices from the computer.
4.Remove the battery (see Battery on page 35).
5.Disconnect the wireless antenna cables from the WLAN module (see Memory module on page 36).
6.Remove the following components:
a.Keyboard (see Keyboard on page 39)
b.Hard drive (see Hard drive on page 45)
c.Top cover (see Top cover on page 49)
Remove the display assembly:
1.Disconnect the display panel cable (1) from the system board.
Component replacement procedures | 67 |