Macrom 42.15, 42.17 owner manual Controls and Indicators, Installation

FEATURES

•MOS-FET Power Supply

The 42.15/42.17 's great power is obtained by means of a special C-Mos-Fet supply unit which offers constant efficiency and requires low electrical input. The results are excellent performances, a linear and wide frequency response with high dynamics.

•GOLD-PLATED RCA INPUT CONNECTIONS

•PROFESSIONAL GOLD-PLATED SCREW-TYPE SUPPLY TERMINALS

•GOLD-PLATED SCREW-TYPE SPEAKER OUTPUT CONNECTIONS

•SPEAKER IMPEDANCE

4 or 2 Ohm for stereo operation, 4 Ohm if mono-bridged

CONTROLS AND INDICATORS

CONTROLS AND INDICATORS (Fig. 2, page 4)

➀ON/OFF indicator

➁Stereo or Mono input signal connector

➂Stereo or Mono input signal selector

√Input gain control

➄Speaker output connector board

≈Fuse

∆Power supply connector board

INSTALLATION

INSTALLATION (Fig. 1, page 3)

Due to the high output power of the amplifier a great amount of heat is generated when the unit is in use. It is therefore necessary to install the unit in a position with good air circulation otherwise the amp will enter the protection mode. The best place to install the amplifier is in the trunk; avoid covering the amp.

1.Place the amplifier at the point of installation chosen and mark the position of the four securing screws provided.

2.Drill the screw holes.

3.Place the amp in the correct position and fit the four tapping screws in.

NOTE: Connect the ground lead to a screw already fixed to the metallic chassis of the car (indicated by * ) in order to ensure a good ground contact.

9