Acer 4732Z/4332 manual System Utilities, Phoenix SecureCore Setup Utility

Chapter 2

System Utilities

Phoenix SecureCore Setup Utility

Phoenix SecureCore Setup Utility is a hardware configuration program built into your system's Basic Input/ Output System (BIOS). Since most systems are already properly configured and optimized, there is normally no need to run this utility.

You will need to run this utility under the following conditions:

•When changing the system configuration including:

•Setting the system time and date

•Configuring the hard drives

•Specifying the boot device sequence

•Configuring the power management modes

•Setting up system passwords or making other changes to the security setup

•When a configuration error is detected by the system and you are prompted ("Run Setup" message) to make changes to the BIOS settings.

IMPORTANT: If you repeatedly receive “Run Setup” messages, the RTC battery located on the mainboard (RTC1) may be defective. In this case, the system cannot retain configuration values in CMOS. Replace the RTC battery with a new one.

NOTE: For ease of reading, Phoenix SecureCore Setup Utility will be simply referred to as “Setup” or “Setup Utility” in this Service Guide.

In the descriptive tables following each of the menu screen illustrations, settings in boldface are the default and suggested parameter settings.

The Setup Utility loads the configuration values in a battery-backed nonvolatile memory called CMOS RAM. This memory area is not part of the system RAM, which allows configuration data to be retained when power is turned off. The values take effect when the system is booted. POST uses these values to configure the hardware. If the values and the actual hardware do not agree, POST generates an error message. You must run this utility to change the BIOS settings from the default or current configuration.

Aspire 4732Z/4332 Service Guide 15