Parameter | Description | Option |
|
|
|
Set HDD Password | When shown as [Locked], the hard drive | Enter |
| password currently can not be changed |
|
| or disabled. |
|
| To change or disable it, turn off the |
|
| system and enter Setup immediately after |
|
| turning it back on. |
|
| Press [Enter] to input change, or disable |
|
| hard drive password. |
|
|
|
|
Password on boot | Defines whether a password is required | Disabled |
| or not while the events defined in this | Enabled |
| group happened. The following sub- |
|
| options are all requires the Supervisor |
|
| password for changes and should be |
|
| grayed out if the user password was used |
|
| to enter setup. |
|
| Allows the user to specify whether or not |
|
| a password is required to boot. |
|
|
|
|
Set Supervisor/User Password
If password on boot is required, the password must be set otherwise it cannot be enabled. The formats of the password are as follows:
Length | No more than 8 characters |
Characters 0-9,A-Z (not case sensitive)
While these fields are highlighted and press “Enter”, a window similar to the following is shown:
Set SupervisorPassword |
| |
Enter New Password | [ | ] |
Confirm New Password | [ | ] |
|
|
|
If there is an old password then setup will prompt with the following window instead and a current password will be required to be entered at first:
Set Supervisor Password |
|
|
Enter current password | [ | ] |
Enter New Password | [ | ] |
Confirm New Password | [ | ] |
|
|
|
Chapter 2 | 39 |