Signal Connections
The Model 112 Stereo Power Amplifier offers unprecedented
compatibility with associated audio components. When Connecting or disconnecting speaker or interconnect cables, it is necessary to place the amplifier in Standby mode (orange POWER INDICATOR LED on the front panel OFF).
1 If you are using balanced XLR interconnects from your preamplifier or source component, position the INPUT SELECT switch to BALANCED INPUT. If you are using unbalanced RCA interconnects, position the INPUT SELECT switch to UNBALANCED INPUT.
2Connect your interconnect cable to one input – either BALANCED INPUTS or UNBALANCED INPUTS – on each channel.
3A slight mechanical click may be heard when the balanced XLR interconnect cables are correctly installed and locked. The unlocking tab (located on the input connector and labeled “PUSH”) must be pressed to disconnect the XLR interconnect cable from the amplifier.
4Unscrew the knob that secures the speaker output connectors on both the LEFT SPEAKER OUTPUT and the RIGHT SPEAKER OUTPUT and pull the securing block out far enough to allow access to the binding posts. Install the positive (usually red) loudspeaker cable spade terminal to the positive (+) binding post and the negative spade terminal to the negative
+Warning: Both positive and negative outputs are electrically
active with respect to chassis and/or system ground potential. Therefore, this amplifier cannot be used in certain loudspeaker switching configurations, such as those used in retail demonstrations. Failure to avoid these precautions can result in damage to the amplifier and will void the warranty.
Remote
1A 12V REMOTE ON/OFF
Signal & 12V
Connections