Yamaha SY-6ICA quick start Can not get my board to run properly

Page 22

SY-6ICAQuick Start Guide

In Device Manager, I keep getting yellow exclamation signs on my sound port even though I have installed my sound driver several times and I could not get my sound card to work. What is wrong?

It is likely that you did not have the correct driver installed. If you are sure that the correct sound driver has been installed, then please install the 'south bridge' driver for the motherboard.

The sound is working in my system, but when I play CD music from the CD- ROM, I do not get any sound. What is wrong?

This is because the 3-wire audio cable from the CD-ROM to the sound card is not connected or it is loose.

The sound from my sound card is distorted when Windows starts. What is wrong?

First, if you are using an ISA sound card, please make sure the IRQ needed for the sound card is set to 'Legacy ISA' in the bios. In other words, if your ISA sound card takes IRQ5, then set IRQ5 to 'Legacy ISA'. Next, install the 'south bridge' driver for the motherboard.

The sound and everything else works fine except that the recorder and microphone do not work. What is wrong?

This is because the recorder and microphone in the Windows are not enabled. Please go to sound properties and enable them.

Lock up (freeze)

When I boot up my system, everything works fine. It sees my CPU and memory, detects my hard drive, floppy drive and CD-ROM but locks up at "Verify DMI pool data... ", and it won’t go any further. What should I do?

Please clear the CMOS via JP5 then choose 'load setup default' in the bios and save the bios and exit. Next, unplug all other add-on cards except the video card and floppy drive controller, and see if it can boot from floppy. Then put back the peripherals one by one to identify which one causes the lockup. If you are running a Cyrix CPU, make sure the 'linear burst function' is enabled in the bios.

I can not get my board to run properly.

Please make sure you have the latest bios and driver from the SOYO web site at: http://www.soyo.com

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Quick Start Guide SY-6ICA Motherboard 6ICA Serial Version 1.0 Edition FebruaryIntroduction SY-6ICA Motherboard Layout Key Features Installation FSB 133MHz Install the CPUFSB 100MHz Retention ModuleConnections to the Motherboard ATX Power On/Off PwrbtATX Power Supply ATX PW Wake-On-LAN Header JP44 CPU Cooling Fan CpufanMemory Configuration Configure MemoryEnable/Disable Power-On by Keyboard JP1 Set JP9 for FWH Boot Block Write-ProtectSet the CPU Frequency PC speaker redirection JP10 CPU Core Voltage Adjust JP15PC speaker Redirection CPU Safe Mode JP7 Cmos Clear JP5Select Soyo Combo Feature Select Standard Cmos FeaturesSelect Load Optimized Defaults Select Save & Exit SetupInsert the Soyo CD into the CD-ROM drive Soyo CD Start Up Program MenuInstall Drivers and Utilities Short description of all available drivers follows Check the Latest Releases Enter the Soyo CDYamaha Soundchip drivers for Windows 98SE Yamaha Soundchip drivers for Windows 95Yamaha Soundchip drivers for Windows Yamaha Codec Application Driver directory Application for windows 95, 98 and 98SEWavetable for windows NT Quick Trouble shoot tips Bios Issues Can not get my board to run properly Soyo Taiwan How to contact usSoyo Europe BV Soyo China Gin Mei Jei Soyo Deutschland GmbHSoyo Hong Kong Soyo JapanPage Edition February Version
Top Page Image Contents