Yamaha SY-6ICA quick start Bios Issues

Page 21

SY-6ICAQuick Start Guide

I get distorted video my AGP card right after I save my bios. Why is that?

The cause is likely that your AGP card is not running at the correct bus speed. To fix this, please clear the CMOS via JP5 and if it still does not work, please upgrade your motherboard bios to the latest version.

BIOS Issues

Where can I find the BIOS revision of my mainboard?

It will be displayed on the up-left corner on the screen during boot-up. It will show as your board type followed by the revision number, such as 5EH_2CA1 (meaning revision 2CA1 for the SY-5EH board) or 6BA+ IV_2AA2 which means SY-6BA+ IV motherboard with 2AA2 bios.

Where can I find the latest BIOS of my motherboard?

Please go to the technical support page of one of the SOYO websites (Taiwan: www.soyo.com.tw), and look up your motherboard to find the latest BIOS revision.

Hard disk, floppy drive, CD-ROM etc

When I boot up my new computer I got "floppy boot failure" and the LED on the floppy stays on

Make sure the red wire of floppy ribbon cable goes to Pin1 on the floppy drive side (don't trust the "key lock" or "notch") and use the end-connector of the cable (don't use middle one).

Modem issues

I get an "I/O Conflict" message when I turn on my system and I can not get my modem to work

What you need to do is to disable 'COM2' (or UART2 or serial port 2) in the bios under integrated peripheral setup.

I have installed my modem drivers several times and I still cannot get my modem to work. Why?

If you are sure that the modem driver has been installed correctly, then you need to install the south bridge driver from the SOYO CD, this is because Windows does not properly recognize relatively new chipsets.

Audio Issues

I do not get any sound from my sound card. What could be wrong?

Please make sure the speaker is connected to the speaker out port on your sound card.

21

Image 21
Contents Quick Start Guide 6ICA Serial Version 1.0 Edition February SY-6ICA MotherboardIntroduction SY-6ICA Motherboard Layout Key Features Installation FSB 100MHz Install the CPUFSB 133MHz Retention ModuleATX Power Supply ATX PW ATX Power On/Off PwrbtConnections to the Motherboard Wake-On-LAN Header JP44 CPU Cooling Fan CpufanConfigure Memory Memory ConfigurationSet JP9 for FWH Boot Block Write-Protect Enable/Disable Power-On by Keyboard JP1Set the CPU Frequency CPU Core Voltage Adjust JP15 PC speaker redirection JP10PC speaker Redirection Cmos Clear JP5 CPU Safe Mode JP7Select Load Optimized Defaults Select Standard Cmos FeaturesSelect Soyo Combo Feature Select Save & Exit SetupSoyo CD Start Up Program Menu Insert the Soyo CD into the CD-ROM driveInstall Drivers and Utilities Short description of all available drivers follows Enter the Soyo CD Check the Latest ReleasesYamaha Soundchip drivers for Windows 95 Yamaha Soundchip drivers for Windows 98SEYamaha Soundchip drivers for Windows Application for windows 95, 98 and 98SE Yamaha Codec Application Driver directoryWavetable for windows NT Quick Trouble shoot tips Bios Issues Can not get my board to run properly How to contact us Soyo TaiwanSoyo Europe BV Soyo Hong Kong Soyo Deutschland GmbHSoyo China Gin Mei Jei Soyo JapanPage Edition February Version