ALTERNATE ATTACHMENT PLATE METHOD
(Phillips screwdrivers, pliers, scissors and appropriate ceiling hooks required)
Plate Hook Bag Contents (AK6 only)
Ceiling
#8 Washer (4)
side
M4 Lock Washer (2) 
3/16” Chain (6 feet) |
| Chain End (4) | Plate Hook |
| as assembled to | ||
|
|
| |
|
|
|
|
Attachment Plate
1.Install the Plate Hook Assemblies in the two “H” holes of the Attachment Plate (see diagram) with the hook ends on the ceiling side as shown above. Use pliers to bend the closed hooks apart just enough to install a Chain End at a later time.
Attachment
Screws
Spacers
Ceiling Mount
adapter
Attachment
Plate
2. Position the projector
projector model. Insert and tighten the required screws through the ceiling mount adapter (not included), then through the designated holes of the Attachment Plate, and then through any required spacers and finally into the projector ceiling mount holes
3.Securely connect the projector assembly to the ceiling mount and then adjust the projector and ceiling mount to center the projector's image in the horizontal center of your screen.
4.Install ceiling hooks (not supplied) into the ceiling directly above the Plate Hooks. The ceiling hooks should be small enough to accept a Chain End but strong enough when installed to each support 40 pounds or more.
5.Attach a Chain End to the Chain and then connect to one of the ceiling hooks. Cut the Chain and assemble to another Chain End for a best fit to the corresponding Plate Hook and attach. Repeat for the other set of hooks.
6.Adjust and tighten the nuts on the Plate Hook Assemblies to make the Chains tight but without raising the front of the Attachment Plate. You may wish to turn the projector on to ensure the image remains properly oriented to the screen during this step. At this point proceed to the appropriate lens/transport mounting step.
Optoma
Page 6