Extron electronic manual Installation and Operation, VSW I AAP Interface, Front panel features

Sleeve ( )

3.5 mm Stereo Plug Connector

(unbalanced)

Installation and Operation

VSW I AAP Interface

The VSW I AAP passive interface features a computer video input and pass-through, an unbalanced stereo input and pass-through, and an input select (Show Me) button. All VGA, audio, and control signals are carried from the rear panel of the AAP to the switcher via a single Extron VGA/audio cable assembly.

Front panel features

SHOW ME

COMPUTER

AUDIO

VSW I AAP

	1	2	3
Figure 1 — Front panel features
A	Computer video input — Input VGA-UXGA, RGBHV, RGBS,
	RGsB, RsGsBs, component video, or HDTV component video

through this 15-pin female VGA connector.

B

C

Audio input — Input unbalanced stereo audio through this 3.5 mm mini audio jack. See the diagram at right.

Input select (Show Me) button — Pressing this button tells the connected and compatible switcher to select this AAP as the switcher's active input.

See "Rear panel features" on the following page.

Tip (L) Ring (R)

NThe connected switcher must be compatible with this VGA pin 5 pull-up control feature. The Extron VSW 2VGA A and SW VGArs series switchers are compatible with this feature. Check the user's manuals for these switchers for more detail.

NThe show me feature will not work when connected to

SW VGArs series switchers with a circuit board part number of 20-527-0xor 20-935-0x.

NUse of the show me feature with specific switchers requires that jumpers be set in the VSW I AAP. See “Setting VSW I AAP Jumpers” on page 4.

1 VSW I AAP • Installation and Operation