Configuration
Setting VSW I AAP Jumpers
A jumper (figure 5) on the VSW I AAP may need to be shifted, from jumper J6 (the default position) to J5, depending on the switcher to which the VSW is connected. Refer to the applicable switcher’s manual to see how to determine the switcher’s board version or level.
J5 J6
Jumper installed | Switcher compatibility |
J6 | VSW 2VGA A, board revision C |
| SW VGArs, board part |
|
|
J5 | VSW 2VGA A, board revision A |
Figure 5 — VSW I AAP jumper positions
•If you are daisy chaining with a VSW 2VGA A that has a circuit board that is revision C or higher, install the jumper on J6.
•If you are daisy chaining with a VSW 2VGA A that has a circuit board that is revision A, install the jumper on J5.
•If you are daisy chaining with a SW VGArs that has a circuit board whose part number is
NThe show me feature will not work when connected to
SW VGArs series switchers with a circuit board part number of