NOTE: Read entire instruction sheet before you start installation and assembly.
WARNING
•Do not begin to install your Peerless product until you have read and understood the instructions and warnings con- tained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call Peerless customer care at
•This product should only be installed by someone of good mechanical aptitude, has experience with basic building construction, and fully understands these instructions.
•Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard- ware and components.
•Never exceed the Maximum UL Load Capacity. See page 1.
•If mounting to wood joist ceilings, make sure that mounting screws are anchored into the center of the joist. Use of an "edge to edge" stud finder is highly recommended.
•Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
•Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding power.
•This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.
•This product was designed and intended to be mounted to the following supporting surfaces checked below with the hardware included in this product as specified in the installation sheet. To mount this product to an alternative sup- porting surface, contact Peerless customer care at 1 800
•This product was designed to be installed on the following ceiling construction only;
CEILING CONSTRUCTION | ADDITIONAL HARDWARE REQUIRED | |
x | Wood Stud | None |
x | Wood Joist | None |
x | Solid Concrete | None |
| Cinder Block | Contact Customer Service (Not Evaluated by UL) |
| Metal Stud | Do not attach except with Peerless accessory kit for metal studs; |
|
| Contact Customer Service for Peerless accessory kit for metal studs. |
|
| (Not Evaluated by UL) |
| Brick | Contact Customer Service (Not Evaluated by UL) |
| Other or unsure? | Contact Customer Service (Not Evaluated by UL) |
Tools Needed for Assembly
•stud finder ("edge to edge" stud finder is recommended)
•phillips screwdriver
•drill
•1/4" bit for concrete surface
•5/32" bit for wood studs
•level
Table of Contents |
|
Parts List | 3 |
Installation to Extension Columns / Ceiling Plate | 4 |
Installation to Wood Joist Ceilings | 5 |
Installation to Concrete Ceilings | 6 |
Installation to Threaded Rods | 7 |
Attaching Adapter Plate to Projector | 8 |
Attaching Adapter Plate to Projector Mount | 9 |
Cable Management | 10 |
Projector Alignment | 11 |
Accessories | 12, 13 |
2 of 13 | ISSUED: |
Visit the Peerless Web Site at www.peerlessmounts.com | For customer care call |