InFocus SP-CEIL-010 installation instructions Adjustable Height Ceiling Installation

Page 4

Adjustable Height Ceiling Installation

Ceiling structure

Wood stud

E

Center of wood stud

Complete the following steps to install the projector mount and projector on your ceiling with the optional suspension adapter.

Adjustable screws

D

This installation works best with high ceilings (FIGURE 3).

Note: Look at the bottom of the upper assembly (D) and locate the arrow. Make sure you install the projector mount with the arrow pointing toward your screen.

Extension adapter

6. Use the Allen wrench (F) to remove the upper plate from the mount assembly (D).

7. Use the Allen wrench to remove the two screws from the enclosed end of the of the suspension adapter, and place it into the slotted extension on the upper plate (E). Make sure that the two (2) outer holes on the suspension adapter align with the holes on the slotted extension on the upper plate.

8. Replace the two screws removed in step 2 into the two (2) holes to secure the suspension adapter to the upper plate.

9. Attach the mount assembly to the suspension adapter and secure them with the two screws removed in step 1.

10. Secure the upper assembly to the ceiling using the commercially available hardware (E) suitable for your environment. Be sure that the upper assembly arrow is pointing toward your screen.

11. Carefully raise the projector (C) with the mounting bracket (B) attached and insert it into the bottom of the upper assembly (D) by its tabs.

12. Rotate the projector (C) with the mounting bracket (B) attached 180º so that the projector’s focus ring is pointing toward your screen.

13. Align the safety knob on the mount assembly with the end of the arrow-shaped slot on the mounting bracket (B) and screw it through the opening to prevent further rotation. Hand-tighten the safety knob.

14. Hand-tighten the remaining two tension knobs to secure the mounting bracket to the amount SEEassemblyFIGURE 3.

CAUTION: Check all of the hardware for proper tightness and security. Do not over-tighten the screws.

C

B

C

D

Insert and rotate 180°

and lock down

A

Solid ceiling structure

NOTE: Use the Allen wrench key (F) for the following modification

Adjustable screws

E

WARNING

When using the optional

extension adapters and making

a height adjustment while

secured to the wall or ceiling do

not remove the screws

completely from the extension. Failure to do so could result in injury and damage to the projector.

Extension adapter

C

B

Insert and rotate 180°

and lock down

C

4

A

Image 4
Contents Before You Start the Installation Installation InstructionsHardware description Tools Needed for Installing the Digital Projector Mount Optional Fixed Height Ceiling InstallationGetting the projector ready Lightmount Plus OverviewInsert and rotate Lock down Adjustable Height Ceiling Installation Wall Mount Installation