4Remove the lamp door by unscrewing the screw then sliding the door off.
5Remove the lamp module by unscrewing the 2 screws then pulling the bail wire. Dispose of the lamp in an environmentally proper manner.
6Install the new lamp module, making sure that it is properly seated. Be careful not to touch the interior components of the projector.
7Snap the bail wire back into its flat position against the lamp module.
8Tighten the single screw.
9Replace the lamp door by sliding the tabs into the tab bays and tighten- ing the two screws.
10Plug in the power cable, then press the Power button on the remote to turn the projector back on.
11Reset the lamp hour timer by navigating to the Service menu and select- ing Lamp Reset. See page 18 for details.
loosen screw on lamp door and slide door off
loosen 2 screws and remove module using bail wire
20