Installing a lens
Please see the Lens Installation Guide for complete information on install- ing a lens.
Appendix
Red LED behavior and projector errors
If the projector is not functioning properly and the red LED is blinking, con- sult Table 2 to determine a possible cause. There are two second pauses between the blinking cycles. Visit www.infocushome.com/support for more details on the red LED error codes.
| Table 2: Red LEDs | |
Red LED Behavior |
| Explanation |
One (1) blink |
| The lamp won't strike after five (5) |
| ||
|
| attempts. Check the lamp and lamp door |
|
| installations for loose connections. |
|
|
|
Three (3) blinks |
| The projector has shut down the lamp. |
|
| Turn off the projector, wait one minute, |
|
| then turn it back on. Or, replace the lamp. |
|
| Contact Technical Support for repair if |
|
| replacing the lamp does not solve the |
|
| problem. |
|
|
|
Four (4) blinks |
| The fan has failed. Replace the lamp. Con- |
|
| tact Technical Support for repair if replac- |
|
| ing the fan does not solve the problem. |
|
|
|
Five (5) blinks |
| The projector is overheating. Check for a |
|
| blocked air vent. Contact Technical Sup- |
|
| port for repair if clearing the air vents |
|
| does not solve the problem. |
|
|
|
22