Kodak 777 manual Connector Panel, Vesa HD15

Connector Panel

The projector provides eight discreet video connectors:

•one red-green-blue RCA (SD/ED/HD component)

•one red-green-blue BNC (SD/ED/HD component)

•two S-video

•one composite RCA

•one M1-DA (HD, RGBHV, HD component, DVI, and computer)

•one VESA (HD, RGBHV, HD component, and computer)

•one D5 (SD/ED/HD component, RGB SCART)

It also has a mini-jack input for a Niles or Xantech-compatible IR repeater and an RS-232 connector for serial control. The Command Line Interface (CLI) specifications and commands are listed in the Appendix starting on page 27.

Two 3.5mm mini-jack triggers provide 12 volt current. Screen trigger pro- vides a constant output while the projector is on. For example, if you con- nect your projection screen to the screen trigger, when you turn on the projector the screen will move down; when you turn the projector off, the screen will return to the storage position. Screen mask provides a 4:3 aspect trigger. When you select 4:3 in the Aspect Ratio menu or from the Resize button on the remote, a 12v signal will be sent after a five second delay. Use this trigger for screens with 4:3 aspect curtains. When you switch back to 16:9 format, the curtains open to reveal the entire screen.

For details on each connector type and their inputs, see page 26.

.

		component	component		serial
		video (BNC)	video (RCA)
					(RS-232)
			status
screen trigger		component 6	component
screen mask		Pr	s-video	3
			5		serial control
			4
				Pr
		Pb
	D5 8	video				M1-DA 1
		7		Pb	vesa 2
					IR in
		Y
				Y
	D5	composite	S-video	VESA (HD15)		DVI (M1-DA)
12v triggers video video (RCA)
					IR input

+12v

ground

3.5mm mono plug for 12 volt current connection

to screen relay (see screen manufacturer for details)

5