InFocus PRJ-WALLKIT-13 installation instructions Cable Management Optional, Add Plastic Covers

PRJ-WALLKIT-13 Installation Instructions

Cable Management (Optional)

1.Route cables/cords from projector through opening on projector arm and route to wall. (See Figure 18)

2.Guide cables/cords from wall end of projector arm upward or downward through slots in wall plate. (See Figure 18)

2
2
	1
Projector arm	Projector
opening

Figure 18

Add Plastic Covers

3.Add end cap (D) to end of short throw projector arm. (See

Figure 20)

3 (D) x 1

(projector not shown)

Figure 20

1.Add right and left plastic covers (E and F) over brackets. (See Figure 19)

2.Fasten covers using four 10-24 x 5/8" Phillips cap head screws (HB). (See Figure 19)

		(projector not shown)
	2	(HB) x 2
	1	(F)
(E)
		1
	(A)
2	(HB) x 2

Figure 19

12 Visit the InFocus support site at www.infocus.com/support