Jabra LP 1000 SERIES manual Inverting the Image, Replacing the Lamp Module

Page 12

I n v e r t i n g t h e I m a g e

NOTE: You can remove the air filter door from the projector while it is still hanging on the ceiling by carefully reaching between the projector and base plate and using a coin to loosen the door.

When you need to remove the projector or clean the air filter:

1Hold the projector from underneath.

2Remove the knurled knob that holds the pro- jector to the mounting plate.

3Slide the projector to release it from the quick release bolts. The projector will come off of the mounting plate. The mounting plate will still be attached to the base box.

4Clean the air filter as described in your LP 1000 User’s Guide if needed.

5Realign the quick release bolts in the keyhole slots on the mounting plate.

6Fasten the knurled knob.

ADJUSTING THE IMAGE

Inverting the Image

1Press the menu button on the remote or key- pad to display the projector’s on-screen menu.

2Using the disk mouse on the remote or the navigation buttons on the keypad, move the cursor to the Controls tab to display the Con- trols menu.

3Move the cursor to the Ceiling Mount box.

4Click either of the two mouse buttons to invert the image.

Replacing the Lamp Module

You don’t need to remove the projector from the ceiling to replace the lamp. Refer to the LP 1000 User’s Guide for lamp removal instructions.

10

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Installation Guide Page Additional LiteMount Products Placing the ProjectorContents Install the Ceiling Mount Base Box on the Ceil- ing Within conduit Install the base box to the LiteMount Pipe Tubing Extension Attach the Mounting Plate to the Projector Hang the Projector on the Ceiling N g t h e P r o j e c t o r o n t h e C e i l i n g Connect the cables and thread through base box Inverting the Image Replacing the Lamp ModuleLimited Warranty Warranty Limitation and ExclusionInstallationsanleitung FÜR DIE Deckenbefestigung LiteMount-ZusatzproduktePlazierung des Projektors LieferumfangDen Deckenbefestigungssockel an der Decke montieren E f e r u m f a n g Befestigung des Sockels an der LiteMount-Rohrverlängerung Die Montageplatte am Projektor befestigen Den Projektor an der Decke aufhängen Befestigung des Projektors am Deckensockel Schließen Sie das Netzkabel sowie die Kabel am Projektor Das Bild invertieren Die Lampe austauschenEingeschränkte Garantie Einschränkung und Ausschluß der Garantie
Top Page Image Contents