Removing the lamp assembly | JVC PK-CL200U instruction

6) Removing the lamp assembly.

Using the hex wrench included with the replacement lamp, loosen the two hex screws fastening the lamp assembly unit. Remove the screws and set aside. When the screws have been removed, remove the lamp assembly by grabbing the handle and sliding the assembly towards you.

7) Install the new lamp unit

Slide the new lamp assembly into the television by holding the han- dle attached to the unit. When the new lamp assembly is securely

installed inside the television,
replace the hex screws using	Handle
the hex wrench. To ensure
the new lamp assembly sits
properly inside the television,
secure the right hex screw
first, then the left. If the lamp
assembly does not sit	Light-source lamp unit
securely inside the television,
the television will not turn on.	Hex wrench

WARNING!

Remember, it is very important you DO NOT TOUCH THE GLASS SURFACE OF THE NEW LAMP. Please re-read the warnings on page 2 regarding the new lamp unit.

This lamp is only for use with the AV-61S902. It is designed to work specifically with the AV-61S902. Using this lamp with a different television or other product could cause a malfunction and/or damage to the television or the lamp.

THE USED LAMP MUST BE RECYCLED IN THE US. See the includ- ed sheet and page 63 of the AV-61S902’s User’s Guide for detailed recycling information for customers in the US.

The lamp assembly in this product contains mercury. Disposal of the lamp assembly may be regulated due to environmental considerations. For information on replacement, disposal or recycling procedures, please contact JVC Customer Relations at 1-800-252-5722.