Warning Messages
If the lamp replacement was successful, the television will operate normally. If there was a problem with the installation, one of several messages may display on the front panel LED lights.
Lamp installed on a slant or not fully inside the television.
If the lamp assembly has been installed into the unit slanted (not flat) or is not fully inserted into the lamp housing inside the television, when the television is turned on the ON TIMER and POWER light will flash. The 10 LEDs will light, then turn off one each five seconds. When all LEDs are off, the television still will not display a picture.
To correct: Reinstall the new lamp assembly. Repeat the lamp instal- lation steps, taking care to observe all warnings. Make sure when the lamp assembly is reinstalled, it is inserted into the unit so it sits FLAT inside the unit.
•If the ON TIMER light and/or POWER light is flashing you need to reset the television. Reset the television by unplugging the power cord from the AC outlet and then plugging the cord back into the outlet again a little later.
Filter not properly reinstalled.
If the filter assembly has not been correctly reinstalled or if the filter has been damaged, the television will not turn on. When the Power button is pressed the 10 LEDs will turn on, then one will turn off every five seconds. When three have turned off the television will then enter a
To correct: Check to see that the filter has been installed properly. Repeat steps 1 to 5 and 8 to 10. You do not need to remove and reinstall the lamp. If the television still does not turn on, the filter may have been damaged. Call a service technician for repair.
If the television does not work properly, or displays a message not listed here, call a technician for service.
8