Dukane LB77H manual Trouble Shooting, Only part of whiteboard can be written on

Page 18

Trouble Shooting

1.If message appears " Failed to verify the IPBOARD, the program can't run further!", please check whether there is a good connection between whiteboard and PC.

zPlease check if cable is connected on both ends.

zCheck if the whiteboard has power. ( red indicator on)

zCheck if a serial port from COM1 to COM4 has been assigned to the board. One serial port from COM1 to COM4 for must be assigned to the whiteboard.

zCheck if the driver of whiteboard has been setup correctly.

zGo to the Icon to the lower right tray and right click for the menu. Select “Orient” and then ”Default Orientation”. The board should then begin normal operation.

2.If during the software startup, the message appears “Error happen when Loading XML File”.

Check the version of Internet Explorer, upgrade IE to version 6.0 if it is 5.0 or lower.

3.Only part of whiteboard can be written on.

zCheck if the model of whiteboard is correctly set.

zCheck if the orientation of whiteboard is correct.

4.Some orientation points do not appear when orienting the whiteboard.

Check if the lateral deviation and vertical offset of projector are correct. Ensure the all the content on PC screen is projected to the whiteboard.

5.Electronic pen does not write normally.

zCheck selected mode of operation. Writing is possible only under the “Draw Mode” or the “Annotation Mode”, and not when in the “Control Mode”.

zDo not press the button on the electronic pen when writing.

zPlease keep the neb of electronic pen vertical to the whiteboard.

zDo not press the electronic pen hard against the board.

zCheck if the battery in the pen needs to be replaced.

6.How to exit from software of whiteboard

zClick the lower icon button ("Pop Menu") on the Floating Tool Bar, then click "Exit" in the menu.

zOr click “File”( on top menu)“Exit”.

7.How to correct the image shape.

zThe projector may not be level. (like, the front is higher than the back or the back is higher than the front). ,

zGenerally, it can be adjusted by using the “keystone correction” or adjusting the height of the projector. For details, please refer to the projector user's manual.

Trapezoid

Rectangle

8.What type of projector is needed with the interactive whiteboard?

17

Image 18
Contents User Guide Page Important Note General NoteContents Introduction FeaturesTopological Diagram System Requirements IntroductionUnpacking the Interactive Whiteboard USB-RS232 Description of Appearance Connecting the Interactive WhiteBoard InstallationInstall Interactive WhiteBoard .Install Battery in the Electronic Pen、Install Leaderboard Software 、Uninstall Leaderboard software Not for the installation Page Page Operating the board Orient calibrate the interactive whiteboardPage Software Operation Function Keys Across bottom of board KeysHow to correct the image shape Trouble ShootingHow to exit from software of whiteboard? Only part of whiteboard can be written onHookup when the serial port is occupied How to clean the panel of IPBOARD?Can 25-pin serial port replace 9-pin serial port? Specifications for the PC and Board Service