MAINTENANCE/HOW to Store, Handling Precautions

MAINTENANCE/HOW TO STORE

Carry out the following maintenance procedures periodically to ensure high quality printing performance at all times.

(1)Cleaning of pages 1-4

When the surface gets stained, wipe it off with a slightly damp cloth. Also, if the stain is particularly stubborn, use a solution of water-thinned neutral detergent to clean. Do not start using the machine until the panel has completely dried.

(2)Cleaning of projection screen (page 5)

Wipe ordinary stains in the same manner as shown in (1).

If something is written on this screen by accident, wipe it off with a cloth dampened with a neutral detergent.

(3)Cleaning of tray and outer frame

Wipe away any dirt or residue left by the markers in the tray and the outer frame with a slightly damp cloth.

HANDLING PRECAUTIONS

<FOR SAFE USE>

1.Avoid placing the machine in hot spots where it is exposed to direct sunlight or next to an air conditioning duct.

2.When using sticky tape on the surface of the panel, do not leave it on for a long time. Moreover, after removing it, wipe the panel clean.

Do not hit or pierce the panel with any hard or sharp objects.

3.Do not leave writing or marks on pages 1-4 for a long time since it may become difficult to erase.

4.As thinner, benzine, alcohol, etc., may discolor or mark the main unit and the panels, (1-4 page) never use such chemicals when cleaning.

5.Use only the correct type of thermal paper.

When storing thermal recording paper, avoid the following places. This is important because storage in such places may cause color development or discoloration.

(1)Places where the paper is exposed to direct sunlight.

(2)Places where the paper is exposed to temperatures of more than 35˚C (95˚F) and humidity of 85% or over.

(3)Places adjacent to alcohol, thinner, benzine, ammonia, etc.