iRobot Robot owner manual Maintenance, Clean Dirt Dog’s brushes

Maintenance

To keep Dirt Dog running at peak performance, it is recommended that you perform the following maintenance tasks every three uses:

1Remove and empty Dirt Dog’s bin

Press button and pull to remove bin

2Clean Dirt Dog’s cliff detect sensors (use compressed air)

Sensors Sensors

3Clean Dirt Dog’s brushes

A.Remove brush guard by pulling both yellow tabs

B. Remove and clean Dirt Dog’s brushes. Remove brush caps and use scissors to cut any hair wrapped around the brush. Use the Dirt Dog cleaning tool to comb hair from brush.

Brushes Brush bearings

Brush caps

C. Remove and clean hair and dirt from Dirt Dog’s brush bearings.

Visit www.irobot.com/usetips

for instructional photos

Tip: Bin emptying and brush cleaning should be done after every 3-5 cleaning cycles depending on the amount of hair, dirt, and debris in your environment.

Tip: If you notice Dirt Dog picking up less debris from your floor, empty the bin and clean the brushes.

Excessive build up of hair in Dirt Dog’s brushes and bearings can permanently damage Dirt Dog. Inspect brush bearings regularly.

Do not attempt to run Dirt Dog without the bearings. If you misplace Dirt Dog’s brush bearings, contact iRobot Customer Care for replacement bearings.

www.irobot.com 19