Altinex VM2144VS, VM2146UX, VM2145SS Installing Your V-MATRIX VIDEO/SYNC Output Cards, Operation

V-MATRIX

INSTALLING YOUR V-MATRIX™
VIDEO/SYNC OUTPUT CARDS	6
Step 1. Slide the VM2144VS/	VM2145SS/

VM2146UX and the VM2143VS into available slots in the V-Matrix™ Enclosure. Make sure that the cards fit into place. Secure the card to the V- Matrix™ by tightening the retainer screws located on the top and bottom of each cover plate.

Step 2. Connect an output cable from the signal source to the input connector of the VM2143VS. Connect the output connector of the VM2144VS/ VM2145SS/ VM2146UX to the display devices through an input cable.

Note: To set jumpers for VM2145SS, see page 6 and 7 for more information. To set jumpers for VM2146UX, see page 8, 9, and 10.

OPERATION 7

The VM2144VS/ VM2145SS/ VM2146UX will operate successfully as long as the card is installed properly and other technical specifications are followed.

TROUBLESHOOTING GUIDE 8

We have carefully tested and have found no problems in the supplied VM2144VS/VM2145SS/ VM2146UX; however, we would like to offer suggestions for the following:

Make sure that power is connected to the enclosure and also check to see if the VM2144VS/ VM2145SS/VM2146UX is pushed in all the way.

Make sure that you have signal sources connected to compatible displays.

If the image quality is poor, please make sure that a high quality of cables is used. We recommend ALTINEX-made cables for best results.

If there is problem with the VM2144VS/ VM2145SS/VM2146UX please call ALTINEX at (714) 990-2300.

11