INTERFACES
CB5100PL- | 200 ft, 5 BNC M to 5 BNC M |
5BM02005BM |
|
CB5100PL- | 250 ft, 5 BNC M to 5 BNC M |
5BM02505BM |
|
All MS81 series cables listed above are 3 ft. long. These cables are also available in 6 ft. and 12 ft. lengths. Please call
FAQ (FREQUENTLY ASKED QUESTIONS) 9
6
use the “HV OUT”
What is a Common Computer Video Card
RGBHV format, turn ON the “HV OUT”
See the following table for Common Computer Video Card
No: 
Question
1Why does the termination switch have to be “ON”?
2When and why do I need to use the “Horizontal Position” Control dial?
3What dip- switch do I set to receive the composite sync output?
4When and why would I use the “Sync on Green” dip- switch, although the unit does not separate Sync from Green?
5
When do I
Answer
The termination switch should be ON if the local monitor is connected through a straight cable. It will be OFF only if a monitor breakout cable is used at the local monitor output connector.
The “Horizontal Position” Control dial enables or disables the control of the Horizontal Position of the image. First adjust the horizontal position using the monitor or projector control, and then use the horizontal position control on the VA6835FC, if needed.
If the desired output signal is composite sync, turn OFF the “HV OUTPUT”
The VA6835FC separates the sync signal from green if the input is RGsB, so the output can be either RGBS or RGBHV. This
If the desired output is in
PIN | MAC | VGA | SUN |
No. |
|
|
|
|
|
|
|
A1 | n/a | n/a | Red |
A2 | n/a | n/a | Green |
A3 | n/a | n/a | Blue |
1 | Red Gnd | Red | N/C |
2 | Red | Green | N/C |
3 | C.Sync | Blue | Sense |
4 | ID Bit 01 | ID Bit | Sense Rtn |
5 | Green | N/C | C. Sync Sens |
6 | Green Gnd. | Red Rtn. | N/C |
7 | ID Bit 02 | Green Rtn. | N/C |
8 | N/C | Blue Rtn. | N/C |
9 | Blue | N/C | N/C |
10 | ID Bit 03 | Gnd | N/C |
11 | C/V Gnd. | ID Bit |
|
12 | V. Sync | ID Bit |
|
13 | Blue Gnd. | H. Sync. |
|
14 | H. Gnd | V. Sync |
|
15 | H. Sync | N/C |
|
Table 8. Common Computer Video Card
11