Alloy Computer Products POE100 Series manual Model, 100Mbps Fibre Transceiver

1. Overview

The POE Series IEEE 802.3u compliant media converters support two types of media 10/100 Base-TX and 100Base-FX. With LFP (Link Fault Propagation) support it allows the administrator to easily diagnose link faults on their network. If the Copper or Fibre link fails, the converter forces the link status of the connecting device to also fail.

The POE100 Series of media converters are designed for applications where the supply of power to attached Ethernet devices needs to be via the network connection, rather than by a power cord. Typical devices that use this method of powering are VoIP Phones, Wireless Access points and IP based Cameras.

The POE100 Series media converters are fully compliant to the IEEE 802.3af standard. The converters include PD (Power Devices – POE120 Series, IP Phones, Wireless Access Points etc.) signature sensing and power monitoring features compliant with the IEEE 802.3af standard, This includes, PD discovery, classification, current limiting and other necessary functions. It also supports high levels of safety support with short circuit protection and power- out auto-detection to the PD.

2. Model Description

	Model		Power Description
POE100 Series		AC: 100 ~ 240V 50 ~ 60Hz
100Mbps Fibre Transceiver				Wavelength
ST/SC Multimode 2Km				1310nm
SC.S05/S20/S40/S60Km Single Mode				1310nm
SC.S80/S100Km Single Mode				1550nm
Single Fibre Model		TX, RX Wavelength
1310nm Single Mode 20Km		TX (Transmit) 1310nm
		RX (Receive) 1550nm
1550nm Single Mode 20Km		TX (Transmit) 1550nm
		RX (Receive) 1310nm

Note:

The 1310nm and 1550nm models must be installed in pairs,

i.e., install 1310nm model at one end and the 1550nm model at the other end.