SC/ST Converter Models

Note:

1.S1-2 and S1-3 will take effect only when S1-1 is set to TP-Force

2.S1-5 must be set to 100FDX for Single Fibre Model

3.S1-6 must be set to POE when you need to supply power to a PD.

Warning:

-When the copper port is set to AUTO and is connected to a device that is forced to 100Mbps FDX, an unknown state may result.

-Please ensure that all network nodes that this device connects to are set to the same mode at each end of the link.

e.g., Both ends are set to Auto-Negotiation mode (AUTO)

9. Cable Distances and Limitations

-TP Cable Limitations: Cat 5 up to 100m

-Fibre Cable Limitations:

10.Technical Specifications

Standards:	IEEE 802.3u 10/100Base-TX, 100Base-FX
	IEEE 802.3af Power Over Ethernet
UTP Cable:	Cat. 5 cable up to 100m
Fibre Cable:	50/125, 62.5/125 or 100/140 µm multi mode
	8.3/125, 8.7/125, 9/125 or 10/125 µm single mode
Power Feeding	Via TP Pins 1, 2, 3 and 6
Support:
LED Indicators:	Power, POE, TP LNK/ACT, 100, FX LNK/ACT,
	FDX/COL, 4W, 7W, 15.4W
Data Transfer Rate:	100Mbbps – 148,800pps
	10Mbps – 14,880pps
Flow Control:	IEEE 802.3x compliant for Full Duplex
	Backpressure flow control for Half Duplex
Power Requirements:	AC 100 ~ 240V 50 ~ 60Hz
Power Consumption:	24W
Ambient Temperature:	0º to 50º C
Humidity:	5% to 90%
Dimensions:	40(H) x 158(W) x 133(D) mm

Complies with C-Tick, FCC Part 15 Class A and CE Mark