Setting the Isdn Territory

8	Port Interface Card

Before you connect an AT-AR020 or AT-AR021 PIC to the ISDN network, check that the ISDN territory is set correctly for your region.

1.Log in to your switch or router.

For more information, see the Installation and Safety Guide included with your switch or router. You can also download the complete documentation for your switch or router from www.alliedtelesis.com/support/software/.

2.Set the territory, using the command:

set system territory={australiachinaeuropejapankorea newzealandusa}

In Australia only:

•To use the Micro service, set the territory to australia.

•To use the OnRamp service, set the territory to europe.

3.Save the configuration.

Save your configuration to a new file by using the command: create config=filename.cfg

Then set the router to load this file when it restarts by using the command: set config=filename.cfg

We recommend leaving the boot.cfg file unchanged, in case you need to revert to the original default configuration.

See the AlliedWare® Operating System Software Reference for more information on configuring ISDN.

Port Interface Card

Setting the ISDN Territory