MULTITASKER
20.[SID+]
This command sets the card ID of all the cards in a system to their slot number plus the offset value.
Command Format: [SID+n]
n= Offset amount (n = # from 0 to 99) The maximum card ID is 99, so subtract the highest slot number from 99 to find the maximum offset. For example, in an
Example:
There are two
Connect the computer to the second unit only. Send [SID+20] to set the ID of all the cards in the second enclosure to their slot number plus 20. Reconnect both units to the computer.
The cards in the first unit will be referenced as card IDs
21.[RSN]
This command displays the slot number of a card with a specified ID number. If more than one card has the same ID, each slot number will be displayed.
Command Format: [RSNCi]
Ci = Card ID (i = # from 1 to 99)
Example:
The card in slot 4 takes up four slots in the enclosure. Its ID was set to 1 since it is the first card installed in the system, reading from left to right. Send the command [RSNC1] to find the slot number of this card. The system responds with the following feedback:
[4]
GROUP COMMANDS
The next few commands are group commands. The use of groups allows several cards with the same functions to be controlled simultaneously using a single command. Up to 8 groups
22.[WR]
This command adds cards to a group allowing all the group members to be controlled simultaneously with the same commands. Each MultiTasker unit may define a maximum of eight groups.
In MultiTasker systems with audio and video cards, the groups are typically as follows:
Group 1 = Video Cards
Group 2 = Audio Cards
Group 3 = Video and Audio Cards
Command Format: [WRCn1Cn2…Gk]
Cn = Card ID (n = slot # from 1 to max slots)
Gk = Group number (k = # from
Example:
Add C2, C4, and C6 to G5 by sending the command [WRC2C4C6G5]. After executing this command, C2, C4, and C6 will be G5. The system will return the following feedback:
[G5=C2C4C6]
Now when a command is sent to G5, each board in G5 will execute the same command.
23.[RMC]
This command may be used to remove one or more group members from a group. Reset the system after using this command for all changes to take effect.
Command Format: [RMCn1Cn2…Gk] Cn = Card ID (n= # from 1 to max slots)
Gk = Group ID (k = # from
14 |