DSL-300T ADSL Modem User’s Guide
To setup a PPPoA connection for the first time:
1.Type in a Name in the space provided if you wish or leave the default name.
2.Make sure PPPoA appears listed as the Type: of connection protocol used.
3.Do not change the VPI or VCI values unless you are required to do so. If these settings are incorrect, the ADSL connection will not function. Many users will be able to use the default settings. If you are told to change these, type in the values given to you by your service provider.
4.Leave the default QoS values if you are unsure or the ISP did not provide this information.
5.Do not change the PCR or SCR values unless you are required to do so. If you are told to change these, type in the values given to you by your service provider.
6.Supply a Username and Password used to verify the identity of your account. These are usually provided by your ISP.
7.The Encapsulation values LLC (SNAP) and VC (MUX) are two different methods of encapsulating the PPP packet. Contact your ISP to make sure which encapsulation is being supported.
8.For most users, the remaining settings will not need to be changed. See your ISP for further information.
9.Click the Apply button when you have entered all the information. The browser window may briefly go blank. After a few seconds the new connection you just configured will become the active connection for the Modem.
10.To make your temporarily saved connection permanent, click the Save All button in the System Commands window on the Tools tab.
20