Performing preventive maintenance

You should replace certain parts when the PERFORM PRINTER MAINTENANCE message appears on the printer control panel display. This will help ensure that your printer maintains optimum performance.

The maintenance message will appear every 200,000 pages. The message can be temporarily cleared for approximately 10,000 pages by using the CLEAR MAINTENANCE MESSAGE item on the Resets submenu. (See Resets submenu.) To check the number of pages the printer has printed since new maintenance-kit components were installed, print either a configuration page or a supplies status page. (See Configuration page or Supplies status page for details.)

 

To order the printer maintenance kit, see Part numbers. The kit includes:

 

●

fuser

 

● rollers (transfer, pickup, and feed)

 

●

installation instructions

 

The printer maintenance kit is a consumable item and is not covered under the original

NOTE

 

printer warranty or under most extended warranties.

After a maintenance kit is installed, the maintenance-kit counter must be reset.

To reset the maintenance-kit counter

1.Turn the printer power off and then on.

2.When XXX appears on the control-panel display, press and hold down (SELECT button). Continue holding down (SELECT button) until all three printer control panel lights flash once, and then stay on. This might take up to 10 seconds.

3.Release (SELECT button) and press (UP button) to scroll to NEW MAINTENANCE KIT.

4.Press (SELECT button) to reset the maintenance-kit counter.

NOTE

Perform this procedure only after a maintenance kit has been installed. Do not use this

 

procedure to temporarily clear the PERFORM PRINTER MAINTENANCE message.

ENWW

Performing preventive maintenance 115