HP 4250/4350 manual Cartridge out, Jam recovery, To set the cartridge-out response

Cartridge out

The printer has two options for this menu item.

●Select CONTINUE to allow the printer to continue printing. A REPLACE CARTRIDGE warning message appears until the print cartridge is replaced. Printing in this mode can continue only for a specific number of pages. After that, the printer stops printing until you replace the empty print cartridge. This is the default setting.

●Select STOP if you want the printer to stop printing until the empty print cartridge is replaced.

To set the cartridge-out response

1.Press MENU to open the menus.

2.Press (DOWN button) to highlight CONFIGURE DEVICE.

3.Press (SELECT button) to select CONFIGURE DEVICE.

4.Press (DOWN button) to highlight SYSTEM SETUP.

5.Press (SELECT button) to select SYSTEM SETUP.

6.Press (DOWN button) to highlight CARTRIDGE OUT.

7.Press (SELECT button) to select CARTRIDGE OUT.

8.Press (UP button) or (DOWN button) to select the appropriate setting.

9.Press (SELECT button) to set the selection.

10.Press MENU to exit the menu.

Jam recovery

Use this option to configure the printer response to jams, including how the printer handles the pages involved. AUTO is the default value.

●AUTO. The printer automatically turns jam recovery on when sufficient memory is available.

●ON. The printer reprints any page that is involved in a jam. Additional memory is allocated to store the last few pages that were printed, and this might cause overall printer performance to suffer.

●OFF. The printer does not reprint any page that was involved in a jam. Because no memory is used to store the most recent pages, overall printer performance might be optimized.

ENWW Control panel 23